How To Change Your Battery
HOW DO I CHANGE THE BATTERY ON THE LAGARD BASIC ELECTRONIC LOCK?
CHANGING YOUR BATTERY
Slide the keypad housing up and carefully pull away from mounting surface to expose battery compartment.
Remove the old 9-Volt alkaline battery. (if you have 2 batteries, replace one at a time)
Remove the connector by unsnapping it from the two terminals on the top of the battery.
Replace with NEW 9-Volt alkaline battery. CAUTION! Hold onto battery terminal connector to avoid pulling the wires out of housing
Carefully position the keypad over the mounting screws and slide the keypad housing down. Ensure there are no wires or cables trapped between the input pad and the safe door. Pinched cables can result in a short circuit.
How to replace your Enforcer and Resistor battery Video
TO VIEW BATTERY CHANGING VIDEO – CLICK HERE
HOW DO I CHANGE THE BATTERY ON THE SECURAM XTREME REDUNDANT ELECTRONIC LOCK?
CHANGING YOUR BATTERY
Lift up tab to turn dial. Turn dial 1/4 turn to the left. Loosen screw. Remove keypad and replace 9 volt battery. Replace keypad and tighten screw. Rotate 1/4 turn to the right and lower the tab for the dial lock.
TO VIEW BATTERY CHANGING VIDEO – CLICK HERE
HOW DO I CHANGE THE BATTERY ON THE LAGARD 700 Series ELECTRONIC LOCK?
CHANGING YOUR BATTERY
Depress button the bottom right of keypad and slide out battery compartment.
Replace 9 Volt Batteries and slide Battery Compartment back into Keypad. Test before Locking the Door.