Proudly Serving - Long Island, NY and the Tri-State Area Call Now To Speak To A Safe Specialist!   

How To Change Your Battery

HOW DO I CHANGE THE BATTERY ON THE LAGARD BASIC ELECTRONIC LOCK?
CHANGING YOUR BATTERY

Slide the keypad housing up and carefully pull away from mounting surface to expose battery compartment.
Remove the old 9-Volt alkaline battery. (if you have 2 batteries, replace one at a time)
Remove the connector by unsnapping it from the two terminals on the top of the battery.
Replace with NEW 9-Volt alkaline battery. CAUTION! Hold onto battery terminal connector to avoid pulling the wires out of housing
Carefully position the keypad over the mounting screws and slide the keypad housing down. Ensure there are no wires or cables trapped between the input pad and the safe door. Pinched cables can result in a short circuit.
How to replace your Enforcer and Resistor battery Video

TO VIEW BATTERY CHANGING VIDEO – CLICK HERE

 

HOW DO I CHANGE THE BATTERY ON THE SECURAM XTREME REDUNDANT ELECTRONIC LOCK?
CHANGING YOUR BATTERY

Lift up tab to turn dial. Turn dial 1/4 turn to the left. Loosen screw. Remove keypad and replace 9 volt battery. Replace keypad and tighten screw. Rotate 1/4 turn to the right and lower the tab for the dial lock. 

TO VIEW BATTERY CHANGING VIDEO – CLICK HERE

 

HOW DO I CHANGE THE BATTERY ON THE LAGARD 700 Series ELECTRONIC LOCK?


CHANGING YOUR BATTERY

Depress button the bottom right of keypad and slide out battery compartment.

Replace 9 Volt Batteries and slide Battery Compartment back into Keypad. Test before Locking the Door.

 

 

 

HOW DO I CHANGE THE BATTERY ON THE S&G 2 Battery Lock

 

 

Two-Battery Keypad
Step 1-Remove the keypad from its mounting base. This can be done by pulling the bottom of the
keypad housing away from the base (photo 1).Grip the keypad housing as shown in the photograph for
best results. Support the keypad housing so that the wires which are attached to its circuit board are not
pulled or stressed. Do not let the keypad hang from its wires.

Step 2-Turn the keypad over and remove both batteries. This is best done by grasping the bottom of
a battery and pulling it gently away from the keypad circuit board. Do not use any type of tool to pry a
battery from its holder.

 

Step 3-lnstallnewbatteries by pushing them directly into the battery connectors attached to the
keypad circuit board. It’s important to support the connectors so they will not get bent during battery
insertion (photo 2).The connectors are designed to make it very difficult to install a battery incorrectly.
Pay close attention to battery polarity so as not to damage a connector by forcing a battery into it
backwards.

Step 4–Hold the keypad housing close to the mounting base while you coil excess wire inside the
housing (photo 3).Position the wire away from the spring clips that hold the keypad housing to the
mounting base.

Step 5-Aiign the spring clips with the receptacles in the base. Using steady pressure, push the
keypad housing back onto its mounting base. Don’t allow any wire(s)to be damaged by contact with the
spring clips. The keypad housing will snap into place on the base.
Step &-Check the master code and all user codes at least three times with the safe door open. Close
the safe door only after the lock has been thoroughly checked for proper operation.
Note: The6120 will operate with just one 9-vo/t alkaline battery attached to either connector. This is only
recommended under emetl8f1Cy conditions when a second battery is not available.